Ultegra R8000 Front Derailleur Cable Routing

The clamp on is easy to set up offers multiple cable routing options and features a natural front shift lever stroke.

Ultegra r8000 front derailleur cable routing.

Shimano ultegra r8000 rear derailleur fitting guide mounting bolt 8 10nm 5mm hex pinch bolt 6 7nm 4mm instagram. The symptom of a front derailleur cable that isn t tight enough is chain rub when it s on the largest chainring and smaller rear cogs. Shimano redesigned it to have a lighter shift action increased frame and tire clearance and to work better with chain lines seen on road bikes with disc brakes and shorter chainstays. Be sure to read this dealer s manual thoroughly before use and follow it for correct use.

Use needle nosed pliers to hold the cable tight and use a 5 mm hex key to tighten the cable fixing bolt. Entering shifters brake cables. It is available in silver and black and braze on and clamp mountings. Ultegra fd r8000 front derailleur the trickle down of dura ace 9100 technology to ultegra r8000 11 speed drivetrains continues with the fd r8000 front derailleur.

Just a few queries regarding the cable installation for ultegra r8000 and which cables derailleur brakes use which end cap types if any. Use the cable cutter to cut the cable 1 to 2 cm past the bolt and use pinch an end cap on the end. Route the cable back through the cable routing on the underside of the bottom bracket and back into the cable fixing bolt on the derailleur. It also matches the wider pitch of the new r8000 crank creating increased compatibility with disc brake road frames.

Front derailleur dura ace fd r9100 ultegra fd r8000 105 fd 5801 procedures for cable tension adjustment and top adjustment differ from those of previous models. The shimano ultegra r8000 series front derailleur offer lighter front shifting operation and easier setup thanks to the new link construction and integrated cable tensioner. Shimano 105 front derailleur brazed on mount road 2x11 speed the new toggle construction on the shimano 105 r7000 front derailleur incorporates an integrated cable tensioner and an optimized cage design that is compatible with disc brake road bikes. Unfortunately this pretty much went away with the advent of internal cable routing.

No end caps derailleur cables. I have a ultegra r8000 in my cannondale supersix and and an old 105 in a.